For equipment installed with slewing bearings, corresponding performance is the focus of users’ attention, and often requires high accuracy. In the application of equipment, the stability of the slewing bearing can meet the requirements of the special work nature of construction equipment, including bearing large axial load, radial load and overturning moment and other comprehensive loads. The following editor will discuss the stability of the slewing bearing with everyone:
In the design of accessories, the rolling elements are usually separated by separate blocks. This structure can maintain the smoothness of movement, so it is widely used. Special applications require special ball or roller spacers. Bearings installed on horizontal shafts or continuously rotating generators and bearings used in occasions with high requirements for positioning and reliability can use strip combined cages to keep the rolling elements in the correct circumferential position .
The purpose of using cages for slewing bearings is very clear: improve bearing rotation performance and efficiency, consolidate bearing stability and reliability, improve bearing design life and service life, and solve the problems of uniform force and bearing structure under complex working conditions . Integral cage-segmented cage-copper cage-steel cage-polyurethane cage-nylon cage-polytetrafluoroethylene cage-PA cage, and composite material cage.
In addition, for slewing bearings, stability and reliability are the two core indicators considered in the selection and design of slewing bearings. The main process design considerations are: structure; material; modulation hardness and quenching hardness; bearing rolling elements and The height and wall thickness ratio of the ferrule; machining accuracy; the material, structure and type of the cage, such as the integral cage, can obviously improve the rotation performance and life of the bearing; the lubrication system and the sealing system; the level of installation and debugging; the daily maintenance Frequency; application of mature design.
In order to ensure the stability of construction equipment, the design of slewing bearings pays more attention to the rationality of the structural configuration, but in many cases, gear teeth can be machined on the inner or outer ring of the bearing to simplify the structure of the drive system. In order to avoid problems, when determining the structure of the drive system, you should seek the help of relevant personnel in the gear.
The above is the discussion about the stability of the slewing bearing. The design of pipe fittings pursues higher performance, but in actual applications, once installation, use or maintenance is improper, various problems may arise, such as in the slewing bearing. There was a problem of excessive shaking during use. The common causes of this are loose installation bolts, causing shaking during work; insufficient rigidity of the steel structure supporting the slewing bearing, elastic deformation during loading, resulting in overall shaking of the slewing bearing, etc., in order to ensure the normal use of the slewing bearing, if you If there is shaking in the machine, it is necessary to stop the machine for inspection in time to prevent long-term shaking from causing greater damage to the slewing bearing